Series V69F | Hi-Build Epoxoline II

Generic Type Polyamidoamine Epoxy
Common Usage An advanced generation epoxy for the protection and finishing of steel and concrete. It has excellent resistance to abrasion and is suitable for immersion as well as chemical contact exposure. Contact your local Tnemec representative for a list of chemicals. This product can also be used as a block filler on cementitious or masonry substrates. Note: Series V69F conforms with air pollution regulations limiting Volatile Organic Compounds (VOC) to a maximum of 250 grams/litre (2.08 lbs/gal) in areas requiring less than 100 grams/litre VOC, please refer to the Series L69F data sheet.

The products listed below are not exact equivalents. They are only products that you may consider as alternatives in a general sense. Substrate type, condition, temperatures, surface preparation, primer/topcoat selection and intended use are just a few factors that will affect product selection. Please contact your local Tnemec Coatings Consultant for product recommendations.

This ProductPolyamidoamine Epoxy
Volume SolidsRec. DFTV.O.C.# of Components
    
Series N69F | Hi-Build Epoxoline II Polyamidoamine Epoxy
Hide this product's data
Volume SolidsRec. DFTV.O.C.# of Components
69.0 ± 2.0% (mixed) †2.0 to 10.0 mils (50 to 255 microns) per coat. Note: The number of coats and thickness requirements will vary with substrate, application method and exposure. Contact your Tnemec representative.N69F
Unthinned: 2.30 lbs/gallon (280 grams/litre)
Thinned 10% (No. 4 Thinner): 2.75 lbs/gallon (330 grams/litre)
Thinned 10% (No. 60 Thinner): 2.76 lbs/gallon (331 grams/litre)

V69F
Unthinned: 1.90 lbs/gallon (228 grams/litre)
Thinned 3.5% (No. 4 Thinner): 2.08 lbs/gallon (250 grams/litre) †		Two: Part A (amine) and Part B (epoxy) — One (Part A) to one (Part B) by volume.

Email this product

Support Documents